#1 24X7 Plumbing and Heating Contractors Waldorf 20603 MD (844-456-4168)

Posted by in Heating Contractors, on October 10, 2017

Plumbing Repair Services in Waldorf 20603

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Waldorf 20603 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Waldorf 20603 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Waldorf 20603 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Waldorf 20603 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Waldorf 20603 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Waldorf Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Waldorf 20603 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Waldorf 20603 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Suitland 20752 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Deale 20751 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors District Heights 20753 MD (844-456-4168)

Plumbing and Heating Contractors Waldorf 20603 MD

Ways to Prevent Washing Machine Leaks: Tighten the hose connections- Hose connections provide water to the hoses which in turn supplies hot and cold water to the washing machine. The moment the spin cycle starts, a lot of pressure is created because water gets filled up in the machine. Not only the hoses but the connections too have to withstand this pressure. It can so happen that with regular use, these connections may become loose and start leaking. To prevent this, you need to check your hose connections from time to time and tighten them up if they appear to be loose.

Ways in Which You Can Prevent Water Damage: Keep a track of your water bill- Whenever your water bill starts showing alarming discrepancies, it is an indication that there is a leak somewhere in your house which is causing loss of water. You should immediately call a plumber to get a thorough check done of all the water supply pipes in your house and get the leak repaired. Small leaks can gradually become big ones and can erode the flooring of your house if you do not pay heed in time. Therefore, it is important to check and compare water bills every time.

Replace Outdated Faucets. Is it time to replace an outdated kitchen or bathroom faucet? Your faucets do more than enhance the appearance of your sink. They also adjust the amount of water passing through. Over time, this can cause an increase in your water bill. Newer eco-friendly designs help control how much water is being used and reduce water flow by up to 30 percent or more. Just choose products with the WaterSense label backed by the EPA. Ask a Ragsdale plumber about installing new faucets in your home.

Salt and Baking Soda: Mix 1/2 cup of table salt with 1/2 cup of baking soda and pour down the blocked drain. Leave it for 10-20 minutes, then pour boiling water down. The salt, baking soda, and boiling water will produce a chemical reaction that should dissolve some of the nastiest blockages. (See also: 27 Uses for Baking Soda)

Clogged toilet? Let it sit for a few hours or overnight, then try flushing again. Often times this is all you’ll need to do, to fix the issue. Just be ready for the water to over flow if this doesn’t work.

Keep an eye out for trouble. When it comes to plumbing, little leaks can lead to big problems. Be alert to signs of impending plumbing failures: Leaking faucets, damp cabinets, rocking toilets or dripping refrigerators all signal problems that need prompt attention.

A wet/dry vac can often suck out a clog

You can use half a lemon to rub away any hard water stains on yourfaucets.

Remember to check that whoever completes the work as taken the relevant plumbing courses and gas courses as they should carry their official Gas Safe registered tradesman identity card to get the work done properly and safely!

Tips to Hire a Local Contractor: Ask Friends and Family for Referrals. Your friends and family are sure to be upfront with you about their experience with plumbing companies that they’ve used. If they had a good experience, definitely ask them for an estimate. It’s very important to get your referrals from people that you know and trust.

How to deal with water damage? Locate a leak and stop it immediately- A small leak can lead to a big crack in the pipe and cause a gushing flow of water to damage your house. If a pipe in your house breaks and floods your house with gallons of water, you need to find the source of the leak and stop the flow of water quickly. For this purpose, you need to shut of the main valve of the water supply pipe of your house. However, even after shutting off the main valve, there can be a lot of water stored in the small water pipes. To drain out this excess water, you should turn on the lowest faucet slowly. This can prevent any further water flow through the leaking pipe.

Ways in Which You Can Prevent Water Damage: Repair frozen pipes- The outdoor water taps tend to freeze up during winter months when the temperature is very low. The water in these pipes gets converted into ice which can put immense pressure on the sides of the pipes. In extreme cases, the pipes can burst and cause flooding. It is important to thaw frozen pipes to avoid such a scenario. To prevent pipes from freezing, you can drain the outdoor faucets so that there is no residual water. You can also shut-off the valve that supplies water to these pipes. This can save you from pipe repairing or replacement expense.

Clean gutters and downspouts: Clean your gutters at least twice a year to avoid blockage and ice dams. Standing water can cause damage to your gutters and roof, and unmanaged overflow may create puddles that could damage your foundation. Don’t forget to clean downspouts to ensure water can flow through, and secure downspouts so that they point away from the home.

The Dreaded Clog: Clogs are the most common toilet problems. Several tools can help you clear a clogged drain. A force-cup plunger is more effective than the familiar standard type for clearing minor clogs. Insert the bulb into the drain, and pump forcefully. Slowly release the handle, letting a little water in so you can see whether the drain is clear. Repeat if necessary. For serious clogs, use a closet auger. Insert the end of the auger into the drain hole, and twist the handle as you push the rotor downward. Use caution not to scratch the bowl.

Clean the Showerhead: Over time, your showerhead gets clogged with all sorts of minerals. Ensure that your shower head is working properly by cleaning it every so often. Remove the showerhead and soak it in vinegar overnight. Wipe down the showerhead and rinse it thoroughly. Reattach the showerhead. That way you can safely remove deposits so that your shower works properly.

Letting Coke soak in your toilet, is the easiest way to clean your bowl.

Ways in Which You Can Prevent Water Damage: Test your sump pump- Sump pumps help in pumping out the water that gets accumulated in the sump basin. These pumps are mostly found in the basements of houses. Sump pumps come in handy during torrential rain or thunderstorms. They get turned on automatically when the sump basin gets filled with water. However, these pumps can become defunct if they are not used for a long time. You need to test whether your sump pump is in proper working condition or not. It is better to keep a spare one as backup so that your house does not get flooded during storms.

Pouring chemicals down your drain will corrode the pipes.

Save Money on Bathroom Modelling – Make sweat equity count. Unless you’ve got loads of time (and expertise) to spend on your project, the best way to add sweat equity is up front, by handling your own demolition, or at the back end, by doing some of the finish work yourself. “If you want to save money, dig in and start helping out,” says Tom Silva. “You can insulate, you can paint, you can sand.” Or better still, he says, help with cleanup every day. “Instead of paying someone to pick up sawdust off the floor, put your money into the time it takes to trim the window properly,” he advises.

Use granite remnants for counters. Granite shops often have small bits of granite left over from bigger jobs and will sell you enough for a bathroom vanity counter at a discount. To find out what’s available, call your local shops first then drop by to see the granite and negotiate the price.

Act quickly if your pipes freeze! Shut down this type of water and open the faucet, enabling it to empty when it thaws. Starting with the faucet, and working your way to the iced-up area, aim a propane torch or hairdryer on the pipe – this will quickly defrost it. You might wrap the pipe inside a heating pad or aim a heat lamp at it, but this may take quite a while. A last resort is to wrap the pipe in rags and pour boiling water over it.

If you live in areas where sewers tend to back up sometimes, then you should consider installing a backflow valve on your floor drain. This functional yet seemingly simple device is designed to inhibit backups to your floor drain.

If your toilet is making noise it can be due to restricted water flow or a defective ball cock assembly. This can be addressed by replacing the entire ball cock assembly or oiling the trip lever. Prior to doing this please make sure to adjust the shut off valve first. Additionally be sure to turn off the water at the fixture shut off valve followed by flushing the toilet to an empty tank. Sponge up any remaining water.

Keep our number handy: 1-888-9TIGER1. You never know when you’ll have a plumbing emergency.

Tips for Fixing Low Water Pressure in Your Home: Do not use all the faucets at the same time- It is the most obvious reason for low pressure of water. Generally, when all the members of the family are at home, the use of faucets increases. This usually happens in the morning and the evening. When all the faucets work at the same time, the water supply to the individual faucets decreases. In order to avoid this problem members of the family should make use of the faucets one buy one. This ensures that all the members experience a proper flow of water.

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
2743 Ridge Avenue
Waldorf, MD 20603

Charles, Maryland (MD)

Telephone: 844-456-4168