#1 24X7 Plumbing and Heating Contractors Upper Marlboro 20775 MD (844-507-4350)

Posted by in Heating Contractors, on February 1, 2018

Plumbing Repair Services in Upper Marlboro 20775

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Upper Marlboro 20775 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Upper Marlboro 20775 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Upper Marlboro 20775 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Upper Marlboro 20775 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Upper Marlboro 20775 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Upper Marlboro Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Upper Marlboro 20775 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Upper Marlboro 20775 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Silver Spring 20906 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Silver Spring 20905 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Silver Spring 20907 MD (844-507-4350)

Plumbing and Heating Contractors Upper Marlboro 20775 MD

Lower the thermostat on your water heater; water heaters sometimes come from the factory with high temperature settings

Tips for repairing burst pipes: Make use of pipe clamps- In case there are no plumbers available when your pipe bursts, you can repair the pipe yourself with the help of clamps. There are various types of clamps available for different leaks. The pipe clamps come with hinges so that you can simply fix the clamp over the leak and tighten it with the help of screws. These clamps work very well during emergencies and are available every where at a low cost. They stop all kinds of leaks immediately and can act as permanent solutions too in case the leak is not very huge.

Use duct tape or pipe sealing tape to pull together a crack in a pipe, reducing the leak as a temporary solution.

Use paint with mildewcide in damp areas: Mildewcide in paint is usually effective for controlling surface mold in damp rooms like bathrooms and outside in shady areas. Many paints already have mildewcide in them. Check with your paint dealer to be sure.

Distilled vinegar can remove hard water stains on your shower head. Just tie a bag of vinegar around your shower head and leave it there for a few hours. Then you can simply wipe away the stains with a cloth.

Ways to Unclog Drains: Apply your knowledge of the law of gravity- In case your bathtub drain pipe is clogged, you just need to fill the bathtub with water to the brink after plugging the drain. Once this process is over, you can unplug the drain and see the effect. The law of gravity works to pull the water into the drain at a tremendous speed. This creates a pressure which helps in washing away the blockage in the drain pipe. You can get a clean drain without much effort.

Clogged toilet? Let it sit for a few hours or overnight, then try flushing again. Often times this is all you’ll need to do, to fix the issue. Just be ready for the water to over flow if this doesn’t work.

DIY plumbing jobs will need which you learn how to solder copper to the lines to the water supply. You can practice this skill which means you have the ability to run your lines without worrying regarding this leaking. Look online for video tutorials which can help you receive a handle on the way to soldering.

Tips for installing and repairing a gas line: Always turn off the gas supply before installation or repair- This is a necessary step which should not be avoided. You should turn off the valve present beside the gas meter before removing the old pipe and replacing it with a new one and also while repairing the present one. In case the valve is open, gas can leak and can lead to a fatal disaster by causing a big fire. The valve should be perpendicular to the pipe when it is closed. There is no change in the gas meter when the valve is closed. You should check all this and then start the gas line work.

Tips for repairing burst pipes: Drain the excess water- After shutting-off the main water supply, you need to make sure that there is no water left in the broken pipe. For this purpose, you need to open all the faucets and flush the toilets. The excess water drains away, leaving the pipe dry and eliminating the possibility of the leaking of water. Once the plumbing system of your house is drained, you can ask a plumber to repair the burst pipe. This makes the process of repairing efficient and quick.

Bathroom Remodelling Tips – Consider popular bathroom design trends. Second sinks have become very popular in bathroom remodels as they allow two people to use the bathroom at the same time. Another popular trend in bathroom design is separating the toilet from the rest of the bathroom. If you only have a shower, consider replacing this with a bathtub which can serve double duty as both a bath and a shower. Whirlpool bathtubs have also become very popular in today’s bathrooms. Nearly everyone elects to include a bathroom exhaust fan, often incorporating a heater on a timer, as well.

The first thing you should do is check the main water valve where the water line enters the home. In most cases, the valve looks like a wagon wheel and it is located at the water meter going into the home. Turn the water valve a half-turn in a clockwise direction so it slightly closes off. Then, turn the valve counter clockwise all the way so that it is completely open. There should be a forceful thrust of water that pushes any deposit through the system and raises the pressure. If you think there is sediment built up in your pipes, open your sink faucet, and then turn the water on and off at the main water valve which loosen mineral deposits and push the mineral deposits through the plumbing system.

Perform a pipe inspection to check for leaks. You may have to look into some hard to see places such as under the home so make sure you use a flashlight. If you find a water leak in a pipe, you will have to get it repaired or replaced. You will have to shut off the main water valve so it can be repaired. It is wise to hire a plumber to do the job.

Tips on Hiring a Plumber: Meet the plumber face-to-face before hiring him- It is not necessary that the person you talk to on the phone is the same person who comes to your house to do the plumbing repair work. It is important to check the credentials of this person and his experience before asking him to do the job. The plumber should be able to answer your queries without fumbling. You can convey your concerns to the plumber by showing him the fault in your plumbing system. The discussion with the plumber regarding various solutions is more convenient when you get to meet him in person.

Use a shop vacuum to remove hard objects. When a hard object like a toothbrush, comb or toy plugs a toilet or drain, a plunger may not be the solution—it might only push the obstruction in deeper. Instead, suck out the water and the obstruction with a wet/dry shop vacuum.

Be Aware of Little Problems: It is often the smallest problems that can mean the most trouble later on. Make sure you are aware of any little leaks or dripping faucets so that they don’t have the chance to get bigger.

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
8155 Highland Avenue
Upper Marlboro, MD 20775

Prince Georges, Maryland (MD)

Telephone: 844-507-4350