#1 24X7 Plumbing and Heating Contractors Laurel 20726 MD (844-507-4350)

Posted by in Heating Contractors, on February 9, 2018

Plumbing Repair Services in Laurel 20726

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Laurel 20726 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Laurel 20726 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Laurel 20726 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Laurel 20726 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Laurel 20726 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Laurel Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Laurel 20726 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Laurel 20726 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Easton 21606 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Easton 21601 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Barclay 21607 MD (844-507-4350)

Plumbing and Heating Contractors Laurel 20726 MD

Check the aerator in the faucets to see if they need to be cleaned. Remove the aerator using pliers or a crescent wrench. You will find a small screen inside of the faucet head. Remove the screen and thoroughly rinse it. Before replacing the screen, turn on the water to see if the water is flowing properly.

Determine the appropriate fuel type for your water heater. If you are considering electricity, check with your local utility company for off-peak electricity rates for water heating.

Single-lever shutoff valve – If you are a conscientious launder like my mother and can remember to turn the water off after each load of wash, replace your dual faucets with a single-lever faucet that lets you controls both hot and cold water at the same time. A low cost solution that’s easy to use! Pick one up at any hardware store for about $25.

Do not use galvanized steel for your plumbing. Galvanized steel can be corrosion ridden. Copper plumbing is your best bet.

Save Money on Bathroom Modelling – Don’t overspend on wall prep. If your walls are in such rough shape that it would take a painting contractor days of filling and sanding to make them ready for the roller, consider using materials such as Texturglas, from Deerfield Beach, Florida— based company Roos International. A breathable, nontoxic wall covering made of fine glass filaments, Texturglas has a similar look and feel to the fiberglass matting used in auto–body work. It’s available in a variety of surface patterns, takes paint readily, and is designed to be installed right on top of existing surfaces, adding strength while covering up dings.

Ditch Commercial Drain Cleaners: If you are using commercial drain cleaners to unclog drains, you should stop it right now. The chemicals in these cleaners may be effective but they erode away your pipes and cause more damage than they’re worth.

Reduce Water Pressure: Many of the problems you are experiencing with your plumbing could be caused by too much water pressure. Be kind to your plumbing and reduce the water pressure as much as you can.

Ways in Which You Can Prevent Water Damage: Keep a track of your water bill- Whenever your water bill starts showing alarming discrepancies, it is an indication that there is a leak somewhere in your house which is causing loss of water. You should immediately call a plumber to get a thorough check done of all the water supply pipes in your house and get the leak repaired. Small leaks can gradually become big ones and can erode the flooring of your house if you do not pay heed in time. Therefore, it is important to check and compare water bills every time.

The Bent Wire Hanger: Simple enough, but surprisingly effective. Take a regular wire coat hanger and straighten it out as best you can. Then, bend one end over to create a small hook. Push that past the drain cover and start fishing. You should be able to get all sorts of hair and nasty stuff out of the drain. Remember, you always want to be pulling gunk out, not pushing it further. When you’ve got as much out as you can, run the hot water, and it should clear things up nicely.

Use strainers on all drains to hold foreign objects and debris from clogging drains. You ought to clean your kitchen area sink’s strainer whenever you will discover a large particle that’s kept in it. Clean bathtub drain screens as frequently when necessary.

When installing a sump pump, it is usually recommended that a check valve be installed, this prevents water left in the outlet pipe from flowing back into the basin

Save Money on Bathroom Modelling – Increase efficiency, not size. If you can reorganize and equip your kitchen for maximum utility, you may not need to blow out the walls to gain square footage. Start by replacing space–hogging shelves with cabinet–height pullout drawers 8 inches wide, containing racks for canned goods and other items. “You’re getting three or more horizontal planes where you might otherwise get only one,” says Louis Smith Jr., an architect with Meier Group, in Ann Arbor, Michigan. You could easily shell out a few thousand to outfit cabinets with upgrades like dividers, pull–out pot trays, and lazy Susans, but you’ll save many times that amount by skipping the addition you thought you needed.

Vinegar: Tried and true method: Remove as much liquid as you can. Toss in 1 cup of baking soda, then pour down a cup of household vinegar, plug with the stopper then let sit for half an hour. After about 30 minutes, unplug and pour a kettle full of hot water on top. See this page from thegoodhuman.com and this this one from treehugger.com for more details. This is the method I’ve grown up with and it works even if there’s still liquid backed up (although it works faster without water). Just double the baking soda & vinegar amount, give it about an hour and things have fully emptied, dump more fresh batches of boiling water 2 or 3 times to completely clear out the gunk.

Tips for maintaining your bathroom plumbing: Make use of a water softener- The water supply that comes to your house from the municipal corporation is hard water which contains a number of heavy minerals. These minerals get deposited in the pipes and corrode it in the long run. In order to prevent this problem, you should invest in a water softener which filters out these elements from the water so that you can get better quality water supply. Your pipes also remain protected from corrosion and this can help in increasing their longevity.

Shower valves: If you are going to design a new bathroom, don’t forget to make sure that you can access the shower and tub valves from the backside of the wall. Placing valves on any outside wall is not a good idea.

When unclogging a kitchen sink, use a second plunger to cover the other drain to get the most force to remove the clog.

Take a look at warm water heater and be sure that this temperature is not really higher than 120 degrees Fahrenheit. If it is, it could possibly force you to get burned or it could reduce the unit’s energy consumption. Should you determine that this temperature is way too high, adjust immediately to protect yourself from any of these things from happening.

Save Money on Bathroom Modelling – Consider look-alikes. Some imitations just make sense: Lumber giant Weyerhaeuser sells a fast-growing natural eucalyptus hybrid under the brand name Lyptus. Sustainably harvested in plantations in Brazil, the clear-grained hardwood looks and feels remarkably like mahogany. It’s sold as toungue-and-groove flooring and in planks and sheets for cabinetry and millwork. (Visit Lyptus.com to find a distributor near you.)

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
9111 High Street
Laurel, MD 20726

Prince Georges, Maryland (MD)

Telephone: 844-507-4350