#1 24X7 Plumbing and Heating Contractors Lanham 20706 MD (844-456-4168)

Posted by in Heating Contractors, on October 2, 2017

Plumbing Repair Services in Lanham 20706

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Lanham 20706 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Lanham 20706 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Lanham 20706 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Lanham 20706 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Lanham 20706 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Lanham Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Lanham 20706 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Lanham 20706 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Havre De Grace 21078 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Henryton 21080 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Harmans 21077 MD (844-456-4168)

Plumbing and Heating Contractors Lanham 20706 MD

Be sure to pour about a gallon of water to drains that you seldom use so as to prevent odors from getting inside your house. Use snakes when dealing with slow drains to ensure that they will function properly in the event of major flooding. Remember drains must be able to efficiently drain water at all times.

A clog can often be yanked out with an easy tool like a Zip-It or other flexible-shaft pick-up tool

A pedestal sump pump works well if you have a smaller diameter basins

Make sure the machine is balanced: It may sound hard to believe, but something as simple as your machine being tilted can cause water to leak. If you’ve recently installed or moved your machine, make sure it is completely level. Even the slightest tilt can cause water to leak from the front of the machine.

Home Improvement Tip – Start with the Bathroom: Consumer reports tell us that 235,000 people wind up in the emergency room each year due to injuries tht occur while showering, taking a bath or using the bathroom. Tub and shower bases with slip free surfaces can eliminate a majority of these injuries. The design of the tub or shower can also come into play. A) Wide Doorways – The doorway should be a minimum of 32 inches wide. In older homes, it’s a narrow 24 inches. When the doorway is only 24 inches a walker or wheelchair will not fit through the bathroom door. B) Stand Up Showers with a Slip Free Base – If you have a small shower make sure to enlarge it so that there is extra room for seating and a walker.

Plunge water first before removing the trap. Before you remove a sink trap, give the drain a few plunges with a toilet plunger. This will push most of the water out of the trap, lessening the mess when you pull the trap. If you have a double sink, be sure to plug the other drain to contain the air pressure. If the strainer isn’t a screw-down style, you’ll have to hold it down while you plunge the drain.

When unclogging a kitchen sink, use a second plunger to cover the other drain to get the most force to remove the clog.

Check the water inlet valve: Locate the water inlet valve and check to see if there is a leaky connection. It may be as simple as tightening the connection to prevent further leaking.

Ditch Commercial Drain Cleaners: If you are using commercial drain cleaners to unclog drains, you should stop it right now. The chemicals in these cleaners may be effective but they erode away your pipes and cause more damage than they’re worth.

Ways in Which You Can Prevent Water Damage: Keep your gutters and downspouts clean- Clogged gutters do not allow the water to drain. The excess water overflows and comes down the side of your house in a cascade. This can cause severe damage to the walls and foundation of your house. You also need to install your downspouts at least 5 to 10 feet away from your house so that there is no pooling of water near it. These gutters and downspouts should be cleaned regularly and specially before the rainy season so that the water gets drained easily.

Outside the house, you should check for bird’s nest that may be blocking plumbing vents. If there is any, be sure to get them out of the way. You should also inspect bibs and faucets to ensure that water is flowing smoothly and freely. Before you turn on the hose, check for possible leaks and look for signs of cracks that may have been brought about by frozen pipes. You certainly would not want to deal with busted pipes so you should make a thorough inspection first before opening your outdoor faucet.

Plastic piping is much easier to install, adjust and tighten if a leak develops, than metal piping

Save Money on Bathroom Modelling – Donate your trash. Before you begin a remodeling job, invite the local Habitat for Humanity chapter to remove materials and fixtures for later resale. “About 85 percent of a house is reusable,” says B.J. Perkins, Habitat’s ReUse program manager, in Austin, Texas. “We can do a total takedown, or do a cherry-pick job and take the cabinets, the tub, the sink, and so on.” You save space in the landfill, collect a charitable tax credit for the donation, and help a good cause. Visit Habitat’s website (see Way to Save #3) to find an affiliate near you.

Small bathroom? A corner toilet is a great way to save space!

Check your pressure regulator because sometimes this can cause low water pressure. The pressure regulator is the device shaped like a bell with a screw at the end. You can normally find the pressure regulator either under the home or below the frontal connection. Often you just have to adjust the screw to restore pressure. Tighten the screw to boost the pressure. Make sure you set it between 45 – 60 psi.

Create a vanity from a piece of old furniture. “If you want to get creative, and you have that creative gene … you can create something unique,” Redd says. If your vanity is wood, refinish or paint it rather than buying a new one. She bought a used piece of furniture for $45, a cultured marble top for $150 and two sinks on closeout for $50 each, creating a unique double vanity for just $245.

If your water pressure is too high, like over 80 pounds per square inch for example, it can cause damage to your faucet and create a leak

Consider a corner sink. If you’ve got a tight space with potential traffic-flow problems due to how the entry door or shower door swings open, then consider putting your sink in the corner to free up space.

Perform a pipe inspection to check for leaks. You may have to look into some hard to see places such as under the home so make sure you use a flashlight. If you find a water leak in a pipe, you will have to get it repaired or replaced. You will have to shut off the main water valve so it can be repaired. It is wise to hire a plumber to do the job.

Examine your faucets for leaks. Look into the knobs as well as the faucet itself. Numerous gallons of water each day can be wasted due to leaks and that’s not good if you’re paying your water bill. By stopping a leak now, you can save yourself lots of money. Leaks can grow with time too, so avoid a disaster and look all faucets for leaks!

Ways to Prevent Washing Machine Leaks: Use a washer floor tray- This is an inexpensive way to prevent leaks from causing a lot of damage to your laundry. You can place a washer tray under your washing machine so that if there is a leak in the future, the water can get accumulated in the tray instead of spreading to the whole room. It is a small precaution which can minimize water damage and slow down the overflow process. The washer tray can also come in handy if you cannot afford to get a repair or replacement done at the moment.

Know Where the Shutoff Valves Are: When you do experience problems, like an overflowing toilet or a pipe that has exploded, you need to shut off the water immediately to prevent further damage. Know where the shutoff valves are so you can prevent the problem from getting worse.

Do not assume that having a large horsepower sump pump will be the best choice for you, do your research before buying

High-efficiency toilets are available in a wide range of models

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
8178 Division Street
Lanham, MD 20706

Prince Georges, Maryland (MD)

Telephone: 844-456-4168