#1 24X7 Plumbing and Heating Contractors Hyattsville 20787 MD (844-456-4168)

Posted by in Heating Contractors, on September 27, 2017

Plumbing Repair Services in Hyattsville 20787

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Hyattsville 20787 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Hyattsville 20787 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Hyattsville 20787 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Hyattsville 20787 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Hyattsville 20787 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Hyattsville Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Hyattsville 20787 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Hyattsville 20787 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Gaithersburg 20884 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Gaithersburg 20883 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Gaithersburg 20885 MD (844-456-4168)

Plumbing and Heating Contractors Hyattsville 20787 MD

The Bowl Empties Slowly: A bowl that empties slowly — also known as a weak flush — is usually the result of clogged holes underneath the rim of the bowl. Use a curved piece of wire to poke gently into each flush hole to clear out any debris. Coat-hanger wire works fine, and a small mirror will help you see under the rim. You can also use wire to loosen debris that may be blocking the siphon jet in the bottom of the drain. Be careful not to scratch the bowl.

Do not install the water heater in an unheated basement.

How to deal with water damage? Get in touch with your insurance company- In case your house is full of water because of a flood or hurricane, you need to contact your insurance company for inspection before shifting or moving anything. This process needs to be quick in order to minimize the damage caused by water stagnation. If you need to move certain things immediately, you should take photographs which can serve as proofs. Once the water remediation inspector checks the extent of damage, you can start the recovery process. Insurance can provide you with financial relief at such a difficult time.

Both tape and dope work equally as well when you’re sealing pipe threads

Try to minimize the length of piping that runs to your bathroom and kitchen.

Tips for installing and repairing a gas line: You need to buy the right pipes and fittings- This is the first step in installing a new gas line. There are so many sizes available but you need to choose the one which can fit into the gas meter. Most of the domestic gas lines make use of 1.5 inch pipes whereas the commercial gas lines require upto 8 inch long pipes. You should always go for a pipe which is longer than your requirement so that it can come in handy in case there is an overlap. It is important to buy the right size and length of pipe so that money spent on it does not get wasted.

If pipes do freeze, don’t panic. First, shut off the water supply to the house, then open a faucet near the blocked area to vent vapors from the frozen water. If you suspect that pipes in the hot water system are frozen, turn off the hot water heater. Use a hair dryer to warm the frozen pipe (never use an open flame to thaw a pipe), starting at the end of the pipe nearest to the tap. (Don’t use a hair dryer in areas of standing water.) You’ll know the pipe has begun to thaw when water begins to trickle from the open faucet. When the flow is restored, check the plumbing carefully for cracks or leaks.

Tips for Choosing the Right Plumber – Timeliness and cleanliness are indicators of professionalism. Your time and your home are important. You should expect the company to treat you with respect by keeping you notified with a time range for when their technician will arrive and the technician should arrive at the time you were told. You should also expect a technician to take all necessary precautions to protect your home. An example of this is wearing shoe covers. A good indicator of cleanliness is the clean, professional appearance of the technician and his tools when he arrives at your home. There is a saying that you can often tell the quality of the work by the tools.

Tips for installing and repairing a gas line: Take precautions before starting any repair work- It is necessary to remove gas line plastic covers to get to the gas pipes which are secure under the covers. This process can release some of the trapped gas. You need to wear a gas mask to prevent inhalation because inhaling such gases can cause health problems. It is also important to wear gloves to avoid contact with the harmful gas. These precautions are mandatory when you are attempting the repair process yourself.

To stop an over flowing toilet locate the valve behind your toilet and turn it off immediately

Disconnect hoses: Standing water in a hose may freeze back into the pipe and create an ice block that, in a best-case scenario, stops your water flow. In the worst cases, it may bust your pipes and create damage to walls, floor and foundation.

Look for Leaks: It’s important that you inspect your bathroom for any signs of leaks. While leaks may seem minor, they can develop into a serious problem, leaving you with lots of water damage to repair and mold to clean. Keep an eye and ear out for leaks so that you can have it fixed as soon as possible. When it comes to taking good care of your home, ensure that your home’s bathroom plumbing is in great condition. For assistance with all your plumbing needs, contact the experts at Thousand Oaks Plumbing. Located in Thousand Oaks, California we help the Conejo Valley, Ventura County, and San Fernando Valley with all their water conservation and plumbing needs.

Check your water meter when no water is being used then check it again about eight hours later. If your meter has moved, that’s a clear sign that you may have a leak

Isolation valves located at each fixture will stop the flow of water to that location. This allows water to continue to service the remainder of the house while the leak is being repaired. It’s a good idea to turn on and off each isolation valve in the house at least once a year to keep them in good working condition.

Ways to Unclog Drains: Put your clothes hanger to good use- It is amazing what a simple wire hanger lying in your cupboard can do. You need to straighten out the wire hanger and form a hook like structure on the one end of it. This hook should be lowered into the drain holes present at the bottom of the sink in order to fish out the obstacle. Generally, the clogging occurs due to the presence of hair or food waste in the pipe which does not get drained with the water. Instead of pushing the dirt further down the pipe, you should pull out as much of it as you can and then switch on the tap to wash away the remaining dirt. This can clean your pipe instantly.

Take a look at warm water heater and be sure that this temperature is not really higher than 120 degrees Fahrenheit. If it is, it could possibly force you to get burned or it could reduce the unit’s energy consumption. Should you determine that this temperature is way too high, adjust immediately to protect yourself from any of these things from happening.

Tips for repairing burst pipes: Check the source of the leak- If a pipe located behind a wall or in the ceiling bursts, you need to pin point the exact location of the leak to stop it. For this purpose, you need to drill a small hole into the drywall and allow the excess water to drain off. Then you can check the area which looks very damp. That is the source of the leak. Once the source is located, you can get the drywall removed from that area and ask a plumber to fix the leak. Drywall is not very expensive to replace so you should take a chance and try this method to solve the pipe bursting problem.

Tips on Hiring a Plumber: You should look for experienced plumbers- There are so many plumbers available out there. It is difficult to know who is better qualified to handle your plumbing job efficiently. To find out whether a plumber is experienced or not, you should contact him on the phone and discuss your problem with him. If he provides a generalized and vague answer, you should get alerted that he is not the right person for you. On the other hand, if a plumber gives you an honest answer, you can book his services without hesitation because he knows his job.

If you feel like the water pressure from your shower is consistently decreasing than it may be time to clean the head. This can be done by dipping the head in a CLR solution.

Water lines: With the passage of time, the galvanized water lines may rust or corrode. It’s a good idea to get copper lines. However, the plastic or PEX pipes can cost less, but are not as durable. Also, they don’t do the job so well.

Perform a pipe inspection to check for leaks. You may have to look into some hard to see places such as under the home so make sure you use a flashlight. If you find a water leak in a pipe, you will have to get it repaired or replaced. You will have to shut off the main water valve so it can be repaired. It is wise to hire a plumber to do the job.

What to look for in your next contractor – Call the company and take note of who answers the phone. A reliable plumber will be easy to get ahold of and will have a secretary answering a phone for him if he is unable to answer his cell phone.

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
2313 Ashley Court
Hyattsville, MD 20787

Prince Georges, Maryland (MD)

Telephone: 844-456-4168