#1 24X7 Plumbing and Heating Contractors Hughesville 20637 MD (844-507-4350)

Posted by in Heating Contractors, on February 9, 2018

Plumbing Repair Services in Hughesville 20637

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Hughesville 20637 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Hughesville 20637 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Hughesville 20637 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Hughesville 20637 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Hughesville 20637 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Hughesville Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Hughesville 20637 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Hughesville 20637 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Mount Airy 21771 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Monrovia 21770 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Middletown 21769 MD (844-507-4350)

Plumbing and Heating Contractors Hughesville 20637 MD

Save Money on Bathroom Modelling – Limit recessed light fixtures. The more recessed lights you put in, the more it’s going to cost,” says Tom Silva, This Old House’s general contractor. In addition to the fixtures, there’s the labor to cut all the holes and insulate them properly. A wall– or ceiling–mounted light can also deliver more wattage, which means you may be able to get away with fewer fixtures.

Determine the appropriate fuel type for your water heater. If you are considering electricity, check with your local utility company for off-peak electricity rates for water heating.

Use duct tape or pipe sealing tape to pull together a crack in a pipe, reducing the leak as a temporary solution.

Plastic piping is cheaper than metal

If you cannot thaw your pipes, don’t force it. Instead, call a licensed plumber.

Tighten everything, but not too tight.

Save Money on Bathroom Modelling – Consult an architect. Depending on the scale of your project, you might not need a full–on architectural commission, which involves extensive meetings, multiple job–site visits, and several sets of construction drawings, to the tune of about 8 percent of a project’s construction budget. You might be able to tap an architect’s design savvy by having him undertake a one–time design consultation. For example, for a $400 flat fee, Baton Rouge architect Kevin Harris will meet with a homeowner, examine the problem, and sketch out a few solutions that could be as simple as opening up a partition wall or moving a door. The homeowner can then give the sketch to a builder or take it to a drafting service, which will charge about $1 to $1.50 a square foot to crank out formal construction drawings.

Know how to turn off the water heater. If it’s a gas water heater, turn the switch to the “pilot” position.

Ways to Prevent Washing Machine Leaks: Take a look at the door seals- It is not always the water hose in the washing machine which can cause leaking. If the rubber gaskets around the doors of front-loading machines are dirty, mold can start developing and can cause cracks in the seal. Small cracks can stretch into big ones within a short time and cause water to leak from the door of the machine. You should check the door seal for the presence of mold or mildew and should eradicate it immediately if you spot this problem.

The Bent Wire Hanger: Simple enough, but surprisingly effective. Take a regular wire coat hanger and straighten it out as best you can. Then, bend one end over to create a small hook. Push that past the drain cover and start fishing. You should be able to get all sorts of hair and nasty stuff out of the drain. Remember, you always want to be pulling gunk out, not pushing it further. When you’ve got as much out as you can, run the hot water, and it should clear things up nicely.

The Drain Snake: This is a fairly low-tech piece of equipment that works wonders. It’s basically a long flexible metal rope with a spiral of metal at the end. The following video shows you just what to do.

Lower the thermostat on your water heater; water heaters sometimes come from the factory with high temperature settings

To determine the size of sump pump you need, you must know how much water you’ll need to be pumped, how high the water will be pumped and the length and size of pipe.

Letting Coke soak in your toilet, is the easiest way to clean your bowl.

Those toilet flushing tabs, are horrible for your toilet and will create major problems down the road

Baking Soda and Vinegar: Mix 1/3rd of a cup of baking soda with 1/3rd of a cup of vinegar in a measuring cup. It will fizz immediately, and you should waste no time pouring it down the clogged drain. The fizzing action will help to remove the gunk, hair, and grime that has built up in the pipe. Let it sit for one hour or even overnight if you can. Flush with hot water. Alternatively, get as much of the dry baking soda as you can down the drain first, then pour on the vinegar. (See also: 30 Household Products Vinegar Can Replace)

WaterSense labeled toilets get the job done

Get a look at hidden spaces. Whether you’re remodelling or just running wire, knowing what’s inside the walls is helpful.

Ways to Prevent Washing Machine Leaks: Check your hoses regularly- Hoses are the main sources of leaks in washing machines. The reason for this is that the force of the water flow in the hoses creates stress on the pipes and leads to small cracks with time. This is quite natural given the amount of pressure that the hose undergoes. You should check your hoses periodically to identify any leaks and get them repaired immediately if you spot any. You can check for leaks by squeezing the hose. If it feels squishy, it is an indication that there is a leak somewhere. You need to replace the pipe as soon as possible to prevent the formation of bigger cracks which can cause flooding.

It is a wise idea to install flood alarms, which is a device that will alert you in case it comes in contact with water. This device is made to notify you of an impending flooding or serious leak problems.

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
7212 Aspen Court
Hughesville, MD 20637

Charles, Maryland (MD)

Telephone: 844-507-4350