#1 24X7 Plumbing and Heating Contractors Fort Washington 20744 MD (844-456-4168)

Posted by in Heating Contractors, on September 23, 2017

Plumbing Repair Services in Fort Washington 20744

24X7 Operation & FREE Consultation Click to Call

Plumbing and Heating Contractors Fort Washington 20744 MD: Got a broken water line? Here is how you can fix it

The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.

Some common reasons for the breaking of water lines

Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Fort Washington 20744 MD.

Things that you need to keep in mind before repairing the pipe

It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.

Plumbing and Heating Contractors Fort Washington 20744 MD

How to fix broken water lines?

Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.

  • Locating the point of the leak

The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Fort Washington 20744 MD keep an eye on that.

  • Digging under the ground

This advice is given by the top rated Plumbing Repair Services in Fort Washington 20744 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.

Plumbing and Heating Contractors Fort Washington Maryland

  • Fixing the visible pipes yourself

When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Fort Washington 20744 MD.

If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Fort Washington 20744 MD.

References

• http://www.instructables.com/id/Water-Line-Leaks-Fix-It-Yourself-Heres-How/

• http://www.oneprojectcloser.com/how-to-repair-underground-water-pipe/

Related Posts:

#1 24X7 Plumbing and Heating Contractors Takoma Park 20913 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Silver Spring 20911 MD (844-456-4168)
#1 24X7 Plumbing and Heating Contractors Takoma Park 20912 MD (844-456-4168)

Plumbing and Heating Contractors Fort Washington 20744 MD

Install non-aerating low-flow faucets and shower heads, to save major bucks on your water bill

Waiting for a response from professionals during gas leak: In case you don’t receive a timely response or due to unavailability of emergency repair service by the service providers, do not wait or jump in yourself. The next best move is to call the local fire department because these days, every fireman is trained to handle gas leaks professionally.

Replace water supply hoses – Over time, water supply hoses can become brittle and burst. Check them periodically and replace your old hoses with the newer types that consist of flexible plastic tubing encased in a stainless steel braided exterior. Better still, upgrade to the new auto-shutoff connector hoses that protect against catastrophic water damage by automatically shutting off the water supply to the washing machine if excess water flow is sensed. These ingenious hoses cost only about $20 each and can be used on washing machines, dishwashers and other plumbing fixtures and appliances.

Doing some research before your heater fails will enable you to select one that most appropriately meets your needs.

Check for a blocked soap drawer: Soap build up can be another cause for a leak. By blocking pipes and drainage tubes, water can’t drain properly. Remove the soap drawer and wash any excess soap off.

Repair broken and cracked windows and doors to prevent frozen pipes.

Check the water inlet valve: Locate the water inlet valve and check to see if there is a leaky connection. It may be as simple as tightening the connection to prevent further leaking.

How to deal with water damage? Make use of humidity sensors- You cannot spot the moisture that gets seeped into the walls or the ceiling. There are humidity sensors which can help you to locate these wet spots. Once you know which places are most affected, you can start the drying or damage repair process from there. This saves time and helps in tracking the amount of moisture trapped in such inaccessible places. If even a small amount of dampness is allowed to exist, it can cause rot and mold formation which can gradually eat away at the foundation of your house and make it hollow from within. Humidity sensors help in preventing this.

Ways to Unclog Drains: Pour boiling water down the drain- This is a quick fix for the problem of clogged drains. Be it bathroom drains or kitchen sink drains, you can pour a significant quantity of boiling water into the drain pipe. This process should be repeated twice or thrice at small intervals. The boiling water can help to dissolve the settled grime along the sides of the drain pipe and break it into small parts so that the waste can flow down with the water and get drained, leaving the pipe clean.

The best way out is to make a short list of highly regarded plumbing companies, then ask for price quote from each. Read customer reviews or you can request for contact information of their past clients. With mediocre plumbers deleted from the list, you can now opt for the least expensive one.

Tips for installing and repairing a gas line: You need to buy the right pipes and fittings- This is the first step in installing a new gas line. There are so many sizes available but you need to choose the one which can fit into the gas meter. Most of the domestic gas lines make use of 1.5 inch pipes whereas the commercial gas lines require upto 8 inch long pipes. You should always go for a pipe which is longer than your requirement so that it can come in handy in case there is an overlap. It is important to buy the right size and length of pipe so that money spent on it does not get wasted.

Ways to Unclog Drains: Apply your knowledge of the law of gravity- In case your bathtub drain pipe is clogged, you just need to fill the bathtub with water to the brink after plugging the drain. Once this process is over, you can unplug the drain and see the effect. The law of gravity works to pull the water into the drain at a tremendous speed. This creates a pressure which helps in washing away the blockage in the drain pipe. You can get a clean drain without much effort.

Tips for maintaining your bathroom plumbing: Repair leaks in faucets and showerheads- Leaking faucets is a problem that many people face frequently. This can happen if the washer breaks due to regular use of the faucet. There can be problems with the shower faucet too which can lead to leaks from the shower head. Dripping faucets and showerheads are very annoying and cause a lot of water damage if they are not repaired quickly. You should call a plumber to check the source of the leaks and get it repaired immediately to solve the problem.

Always know where the main water shut-off valve is located in case of a leak.

In case of serious plumbing problems, it is advised that you get the service of qualified professionals, such as a Dallas plumber or plumbers Atlanta. Doing so will give you the guarantee that all your plumbing concerns will be addressed accordingly.

Install water detection devices: A water detector is a small electronic device that sounds an alarm when its sensor comes in contact with moisture. Its main benefit is that it detects low moisture levels or slow leaks that often go unnoticed. Install it near water heaters, sump pumps, washing machines, dishwashers and toilets to prevent extensive damage and mold growth.

Staying in building during a major gas leak: The peculiar odor of gas is an obvious indication of a major gas leak in the house or the building. It is crucial that you leave the place/building immediately without causing a delay in figuring out the reason for smell. It’s time you should immediately call for the professional assistance of gas line repair in Mansfield, TX. Meanwhile, the best you can do is to cut off the supply, through an emergency switch or gas meter.

Tips for Fixing Low Water Pressure in Your Home: Locate the water pressure regulator- Many times a water pressure regulator is attached to the main supply valve. It is a wheel-like structure which can either decrease or increase the supply pressure. You can check whether your main supply valve has a regulator or not. If it is there, you can simply adjust it to increase the pressure of the flow of water to your house. It is better to leave this job to a plumber because the regulator is very tight and needs specific tools in order to make adjustments. The plumber also knows how much pressure your pipes can bear so he can make changes accordingly.

To determine the size of sump pump you need, you must know how much water you’ll need to be pumped, how high the water will be pumped and the length and size of pipe.

What to look for in your next contractor – Do they guarantee their work? It is an industry standard to verify labor and parts. Be wary of any plumber that does not offer any type of guarantee.

Clogged toilet? Let it sit for a few hours or overnight, then try flushing again. Often times this is all you’ll need to do, to fix the issue. Just be ready for the water to over flow if this doesn’t work.

How to deal with water damage? Start cleaning up immediately- The longer you wait to start the cleaning process, the more damage is caused due to dampness. Things which could have been saved, reach a stage where they become beyond repair. Delay in cleaning up can cause the walls to become soft and weak due to moisture. It can lead to growth of mold which can be very difficult to eradicate. In order to avoid the financial costs of replacing so many damaged items, you should sort out the items and keep them out for drying. The flooring should be wiped clean after mopping of water and all ventilation sources should be opened to facilitate the drying process.

You can also add some hot or boiling water to your bowl and try flushing, to correct a clog.

Get a look at hidden spaces. Whether you’re remodelling or just running wire, knowing what’s inside the walls is helpful.

Plumbing Repair Services

We connect you to the best Plumbing Emergency Firms in your city!
3516 Main Street West
Fort Washington, MD 20744

Prince Georges, Maryland (MD)

Telephone: 844-456-4168