#1 24X7 Plumbing and Heating Contractors Bowie 20721 MD (844-507-4350)Posted by Lee in Heating Contractors, on February 1, 2018
Plumbing Repair Services in Bowie 20721
24X7 Operation & FREE Consultation Click to Call
Plumbing and Heating Contractors Bowie 20721 MD: Got a broken water line? Here is how you can fix it
The water pipe does not give a warning before breaking. You only get to see the results after the deed is done. The sudden gush of water is the obvious indication of a broken water line. When a water line inside the home gets damaged, it is still easy to fix because it is visible. But in case the underground water line breaks, you need to dig deep into the ground and fix it. This means more hassle and expense. You can go through the tips given below to reduce the expenditure and learn how to fix broken water lines yourself.
Some common reasons for the breaking of water lines
Usually, fittings and connections in the water pipe are the first to get affected and develop cracks which leak and eventually erode the PVC pipe to such an extent that it breaks. The underground water lines located under the foundation of the home or between the street and the house break due to deterioration with the passage of time or due to pressure. In some cases, these pipes burst due to freezing. Water lines also break during earthquakes. When you hear a rumbling or hissing sound coming from the main water line even when you are not using any of the faucets, it means that the main water line has developed a crack. Also, when the pressure of water is lower than usual, it indicates the loss of water due to a leak in the pipe. In such cases, it is very important that you know how to fix broken water lines. Or call us today and we can help you find the best Plumbing Emergency Firms in Bowie 20721 MD.
Things that you need to keep in mind before repairing the pipe
It is important to evaluate the condition of the pipe before going for a repair. If the pipe is very old, it is better to replace it rather than trying to repair it. In case the pipe has been repaired before, then too replacement is a good choice. If the pipe has developed a crack for the first time, you should consider removing the whole pipe rather than replacing only the damaged part. The reason is that a repaired pipe is more likely to develop cracks again. So instead of spending money twice on repairing, it is wiser to spend it once and install a new pipe which will last longer. Pipe materials like PVC can be easily repaired but lead based pipes become brittle and corroded with time and hence, need to be replaced.
How to fix broken water lines?
Here are some tips which might prove to be useful in case you want to learn how to fix broken water lines.
- Locating the point of the leak
The first thing is to find the crack. The cracks in the pipes located inside the house are evident but the underground pipes are not visible. When these pipes break, the accumulation of water above the ground or the wet mud gives an indication of the leak. If the pipe located behind the wall of the home breaks, you need to put your ear to the wall and locate the leak. When your pump is running and the water meter is moving without any of your faucets being on, it means there is a leak somewhere. That is why professionals and Plumbing Contractors Bowie 20721 MD keep an eye on that.
- Digging under the ground
This advice is given by the top rated Plumbing Repair Services in Bowie 20721 MD. The pipes located underground can be repaired only after you dig them out. This is something which you cannot do yourself. You should find a reputable water main contractor to identify the problem and get it fixed. You also need to call your utility company to mark underground pipes and wires so that they do not get damaged when you dig for the water line. When the water line breaks outside the house, the pipe is dug out from the yard to the house. Then it is cut and removed and replaced with a new pipe. The new pipe should be connected with the existing one and all the indoor and outdoor joints should be sealed. You should always check for leaks after the repair work is over. There is also a no-dig repair method in which a resin pipe lining is put in to the pipe till the place of the break. It is then inflated with air so that it touches the wall of the pipe and hardens to seal the pipe. This is called the Cured in Place Pipe method. A minor break can be repaired by putting a sleeve around the pipe or by replacing only that small portion of the pipe.
- Fixing the visible pipes yourself
When you see a sudden gush of water from any pipe of your house, you should first shut-off the main valve. A small leak can be closed by placing a piece of rubber or any other sealing agent available on the leak. You can then put a C-clamp on it to tighten the seal. A sleeve clamp can also be fixed using a screwdriver. It stops both small and large leaks. These plumbing repair items like hose clamps, duct tapes, rubber and C-clamps are very cheap and can be stored at home in anticipation of such problems. If you want to replace the pipe yourself, then you first need to identify which kind of pipe you have. Once that is done, you need to cut the pipe from the place where it has cracked. The next step is to attach a new pipe to the existing one with the help of fittings and clamps. Finally, the repaired pipe is connected to the faucet and it is ready to be used. Or you can give us a call and we will connect you to the best Plumbing Companies in Bowie 20721 MD.
If you follow some of these tips, you can save a lot of money and effort. You can fix the minor leaks yourself, but in case of major leaks or underground damage, it is better to take the help of a professional and licensed plumber. These are some of the things that you need to keep in mind when you are trying to repair a broken pipe line. Now you have all enough information to target the best Plumbing and Heating Contractors Bowie 20721 MD.
Related Posts:#1 24X7 Plumbing and Heating Contractors Glen Burnie 21061 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Glen Burnie 21062 MD (844-507-4350)
#1 24X7 Plumbing and Heating Contractors Glen Burnie 21060 MD (844-507-4350)
Plumbing and Heating Contractors Bowie 20721 MD
Check your pressure regulator because sometimes this can cause low water pressure. The pressure regulator is the device shaped like a bell with a screw at the end. You can normally find the pressure regulator either under the home or below the frontal connection. Often you just have to adjust the screw to restore pressure. Tighten the screw to boost the pressure. Make sure you set it between 45 – 60 psi.
Take a picture before closing up walls. Your walls may not have much inner beauty, but it’s a good idea to take pictures of what’s inside during remodeling. The same goes for floors and ceilings. When your next remodeling or repair project rolls around, you’ll know where the framing and the electrical and plumbing lines are.
Boiling Water: Tips don’t get any easier than this. Put the kettle on (or use the stove or microwave if you don’t own a kettle) and boil up as much water as it will hold. Now pour it slowly down the drain in two to three stages, allowing the hot water to work for a several seconds in between each pour. This is usually the easiest and quickest way to unclog a drain. If there’s any water left, congratulate yourself with a cup of tea.
Duct tape and leak sealing tape can help out in a plumbing emergency until a permanent fix can be made. Teflon tape will seal up leaks from around threaded connections.
Isolation valves located at each fixture will stop the flow of water to that location. This allows water to continue to service the remainder of the house while the leak is being repaired. It’s a good idea to turn on and off each isolation valve in the house at least once a year to keep them in good working condition.
Clogged toilet? Let it sit for a few hours or overnight, then try flushing again. Often times this is all you’ll need to do, to fix the issue. Just be ready for the water to over flow if this doesn’t work.
Ways in Which You Can Prevent Water Damage: Check the bathroom flooring- Washrooms contain the maximum water supply pipes in the house. These pipes are more prone to damage because of regular use. If they start leaking, they can make the floor damp. Soft spots created by this dampness are generally seen around toilets, sinks, tubs and showers. You should immediately call the plumber to fix the leak to prevent the dampness from spreading to other parts of the bathroom or the house.
To determine the size of sump pump you need, you must know how much water you’ll need to be pumped, how high the water will be pumped and the length and size of pipe.
Ensure that Each Drain Has a Filter. As residential plumbers can vouch, placing filters over each drain in your home prevents clogs and costly plumbing repair.
Tips on Hiring a Plumber: You should ask for references- If you are planning a remodelling project for your home for which you require the help of a professional plumber, then you should definitely ask him to provide examples of his past work. This can give you an idea whether you are hiring the right person for the remodelling job or not. If the plumber is hesitant to supply examples, it means that he is not sure about the standard of his work. You should be able to trust the plumber because you are planning to give a big responsibility to him. Only if the references and examples are satisfactory, you should hire his services.
Know your water main: Know the location of your water main, and shut it off if you leave for an extended amount of time. If no water goes in to the house, chances are no faucet drips can wreak havoc on your home while you’re away.
Have an older shower head? You can save up to 7.5 gallons of water per minute by replacing it with a newer model.
A large horsepower sump pump, in a small diameter basin will cause the pump to cycle more frequently, shortening your pumps life.
Tips for maintaining plumbing during winter: Check your sump pump- The sump pump is essential for draining the excess water. It gets activated when it comes in touch with water and starts pumping water out. It is a good idea to take a look at it in the fall season to check whether it is in proper working condition or not. If it is clogged, you should give it a good clean-up. You should also pour a bucket of water over it to make sure that it is getting turned on. If there is a problem with the sump pump, water can freeze over it in winter and cause damage.
Tips for installing and repairing a gas line: You need to buy the right pipes and fittings- This is the first step in installing a new gas line. There are so many sizes available but you need to choose the one which can fit into the gas meter. Most of the domestic gas lines make use of 1.5 inch pipes whereas the commercial gas lines require upto 8 inch long pipes. You should always go for a pipe which is longer than your requirement so that it can come in handy in case there is an overlap. It is important to buy the right size and length of pipe so that money spent on it does not get wasted.
Tips for installing and repairing a gas line: Always test the pipe before using it- Whenever you carry out a repair or replacement work on your gas lines, you should check the pipe for leaks before starting regular use of the gas line. For this purpose, you need to switch on the gas burner for some time and see whether gas is leaking or not. If there is a leak, you can get a distinct smell and hear a hissing sound coming from the pipe line. You need to turn off the gas immediately and seal the leaks. You should repeat this checking process till you are completely satisfied that there are no leaks.
A cup plunger can be used for small drains like bath tubs, showers and lavatory sinks. Forced cup plungers have a funnel that can apply extra force down the drain, which is good for sinks or toilets.
Plumbing Repair Services
Bowie, MD 20721
Prince Georges, Maryland (MD)